CFWMV - ALPHA ALUMINA FUSED ALUMINUM OXIDE, AWP
- MSDS: CFWMV
- Manufacturer: EXOLON ESK CO
- Product Name: ALPHA ALUMINA FUSED ALUMINUM OXIDE, AWP
- National Stock Number: 5350-00N081252
Product Identification
Product ID:ALPHA ALUMINA FUSED ALUMINUM OXIDE, AWP
MSDS Date:06/03/1994
FSC:5350
NIIN:00N081252
MSDS Number: CFWMV
Responsible Party
TONAWANDA, NY 14150
US
Emergency Phone: 716-693-4550
Info Phone: 716-693-4550
Preparer: RONALD J. SZATKOWSKI
Cage: HO461
Contractor
Telephone: 800-962-1100/716-693-9430
Cage: HO461
Ingredients
3); (ALPHA ALUMINA (AL*2O*3)) (SARA 313)
CAS: 1344-28-1
RTECS: BD1200000
Fraction By Weight: 96-100%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
TITANIUM OXIDE; (TITANIUM DIOXIDE) (TIO*2)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 0-4%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE CONTACT:PARTICULATE MAY
CAUSE SLIGHT TO MODERATE IRRITATION. ABRASIVE ACTION OF DUST CAN
DAMAGE EYES. SKIN CONTACT:NO EVIDENCE OF ADVERSE EFFECTS EXPECTED.
INHALATION:INHALATION OF AIRBORNE PARTICULATE MAY CAUSE SLIGHT TO
MODERATE IRRITATION OF MUCOUS MEMBRANES. CHRONIC:NONE.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:IRRITATION, SHORTNESS OF BREATH, DECREASED
CHEST EXPANSION, DRY COUGH, FATIGUE.
Medical Cond Aggravated by Exposure:INDIVIDUALS W/LUNG DISORDERS SHOULD
NOT BE EXPOSED TO CONDITIONS WHERE LARGE AIRBORNE QUANTITIES OF
NUISANCE DUST EXISTS W/OUT PRECAUTIONS TAKEN TO ALLEVIATE
AGGRAVATED PREEXISTING MEDICAL CONDITION.
First Aid
First Aid:INHAL:IMMED REMOVE VICTIM FROM ADVERSE ENVIRON TO FRESH AIR &
SEEK MED ATTN. EYES:IMMED FLUSH W/LG AMTS OF RUNNING WATER AS
NEEDED, FOR AT LST 15 MINS. IF SYMPS PERSIST, SEEK MED ATTN.
SKIN:WASH CONTA M AREA W/SOAP & WATER. REMOVE & WASH CONTAM CLTHG.
IF RASH, IRRIT/OTHER SYMPS PERSIST, SEEK MED ATTN. INGEST:LEAVE
DECISION TO INDUCE VOMIT FOR MD, SINCE PARTICLES MAY BE ASPIR INTO
LUNGS. (SUPP DATA)
Fire Fighting
Extinguishing Media:AS APPROPRIATE FOR SURROUNDING FIRE.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . AS APPROPRIATE FOR SURROUNDING FIRE.
Unusual Fire/Explosion Hazard:THIS ABRASIVE PRODUCT IS NON-COMBUSTIBLE
& DOES NOT POSE FIRE OR EXPLOSION HAZARDS & WILL NOT INITIATE OR
CONTRIBUTE TO INTENSITY OF FIRE.
Accidental Release
Spill Release Procedures:IF THERE IS SPILL OF PROD, FOLLOWING PRECS
SHOULD BE TAKEN. CLEAN UP USING METHS WHICH AVOID DUST GENERATION.
IF VACUUM IS USED, EXHST AIR SHOULD BE FILTERED BY HIGH-EFFICIENCY
PARTICULATE AIR (HEPA) FILTER. COMPRESSED AIR SHOULD NOT BE USED
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP PROD IN CNTNRS. HANDLE IN SUCH A
WAY TO MINIMIZE FROM BECOMING DISPERSED IN WORK ENVIRONMENT. STORE
IN CNTNRS INDEFINITELY W/NO RISK OF HLTH HAZ.
Other Precautions:UTILIZE APPROVED NIOSH APPROVED DUST RESPIRATOR WHEN
ACUTE DUSTINESS HAS OCCURRED IN WORK ENVIRONMENTS. PROD DOES NOT
POSE SIGNIFICANT FIRE/HLTH HAZS. ABRASIVE PARTICULATE MAY BE IRRIT
TO EYES & RESP TRACT. PROD IS NON-COMBUST & STABLE.
Exposure Controls
Respiratory Protection:USE APPROP NIOSH APPROVED RESPIRATOR IF AIRBORNE
CONTAM CONC EXCEED APPLIC OSHA PEL OR ACGIH TLV, OR OTHER INDUSTRY
STDS/GUIDELINES ON EXPOS. IF RESP PROT IS REQD, ALL APPROP
REQUIREMENTS AS SET FORTH IN 29 CFR 1910.134 MUST BE MET.
Ventilation:USE LOC &/OR GEN DILUTION VENT, AS NEEDED, TO REDUCE
EMPLOYEE EXPOS TO BELOW APPLIC OSHA PEL'S & ACGIH TLV'S.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA . CLTHG WHICH MINS SKIN EXPOS TO ABRASIVE
DUST.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FIRST AID PROC:SEEK IMMED MED ATTN. SPILL PROC:TO CLEAN UP SPILLS.
DURING CLEANUP, SKIN & EYE CONT & INHAL OF DUST SHOULD BE AVOIDED
AS MUCH AS POSS. WHEN NEC, WEAR APPROP PPE (SEE EXPOS CONTROLS/PERS
ONAL PROT MEASURES SECTION) DURING CLEAN-UP OPERATIONS. PLACE MATL
INTO CLEAN, DRY CNTNR W/CLEAN SHOVEL & COVER.
Chemical Properties
Boiling Pt:B.P. Text:6332F,3500C
Melt/Freeze Pt:M.P/F.P Text:3632F,2000C
Spec Gravity:3.97 (H*2O=1)
Solubility in Water:INSOLUBLE
Appearance and Odor:WHITE &/OR BROWN GRANULAR OR FINE POWDER; NO ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:CONTACT W/INCOMPATIBLE MATERIALS.
Disposal
Waste Disposal Methods:COMPLY W/FEDERAL, STATE & LOCAL REGULATIONS
REGARDING REPORTING OF SPILLS & DISPOSAL.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.